Self-Auto Kit Setup Instructions
Instructions main page

First you will need to clean and sterilize everything that you received in your package with warm soapy water and a little alcohol or light bleach solution. Now, set up your water incubator.

Put the submersible heater down in the bottom of the largest chamber that you received that doesn't have any holes in it. It should be the clear plastic tub unlike the picture above. Position the heater in the middle of the chamber, fill about 1/3 with water and a cap full of household bleach and set to desired temperature. NOTE: this heater is submersible. It can be completely underwater with the cord running out of the side. Do not drill any holes!

Now you will want to slide your grow chamber on top of your incubator. This is the smaller blue chamber with the small hole drilled in the side. Set it right on top so that it floats right on top of the water in the incubator. Your temp gauge can read inside and outside temperature. Place the gauge inside the chamber to monitor the temp like so. The gauge itself reads the temp/humidity and the little gauge on the wire can read inside the box when the regular gauge is outside the box. 

This is the hose that comes from your humidifier to provide moist clean air to your grow chamber. Simply attach the hose to the rod if it is not already attached for you. You can position however you like inside the chamber.The suction cups for the tube is in the humidifier for packaging purposes. Use some  good, strong tape and make sure not to cover any of the holes on the rod.

 

Both of the air hoses coming from the air pump are leading into the intake of this device. Then the outtake hose should be leading to your humidifier:

This is the humidifier. It has an intake and an outtake. The outtake hose leading from the previous device should be leading into the intake of the humidifier. That is the hose with the little blue ball on it. (This is a water diffuser) This means that the air pump is blowing both of it's air holes into the humidifier. The outtake hose on the humidifier should be connected with the hose that goes to the grow chamber. Fill the humidifier with spring water and screw on the top.

Your timer is digital and very easy to use. Simply follow the instructions on the back. We recommend that you use these techniques when using the White Rabbit with the timer.

Cake method = 2 inch *wetted layer of perlite at the bottom of the White Rabbit. run for 1 hour every 12 hours.

Casing techniques =  No perlite. Timer set at 15-30 minute intervals every 3 hours

*Add enough spring water to the perlite to where it is completely absorbed and there is a little water left over.